AWeber on Classic accounts
Keep sending contacts from your Classic campaigns to AWeber with an Add to AWeber step.
If your Classic account already used AWeber, you can keep sending the contacts your campaigns collect there. Its connection is under Settings > Integrations, and an Add to AWeber step in a campaign sends each person who reaches it.
AWeber is only offered to Classic accounts that used it before. To set up a new email tool, use Mailchimp, Kit, ActiveCampaign, HubSpot or Zapier.
Connect or reconnect AWeber
- Go to Settings > Integrations.
- Under CRM and email tools, find AWeber and click Connect.
- Fill in Consumer key, Consumer secret, Access key and Access secret from your AWeber account, and confirm. You'll see "Connected."
If AWeber shows Error or Needs reconnect, click Disconnect, then connect it again with fresh details. Disconnecting takes the AWeber step out of your campaigns, so add it back afterwards (the warning names each campaign).
Add the step to a campaign
- Open the campaign under Campaigns.
- Click Add a step where you want it, after the email question.
- Under Integrations, choose Add to AWeber.
- Fill in the settings below, and click Add & save.
Settings
- List ID. The AWeber list to add each person to.
- Sync additional data. The email address always syncs. To send more, click Add data mapping and pair a Field in your email tool with a Textiful field, such as
FNAMEwithfirst_name.
Everyone who reaches the step is sent to AWeber. People who stop before it aren't.